DK 145.000 / Rev. 1.1.0 / 2010-07-18 Specifications subject to change without notice. Errors and misprints excepted. © 2010 Dallmeier electronic www.dallmeier.com / info@dallmeier.comCommissioning VMC-1Video Management CenterTechnical DataMonitorSize 6" TFTResolution 640 × 480 pixelComplete SystemPower supply 12 V DCPower consumption Approx. 30 WOperating temperature +5 °C to +35 °CHumidity 10 – 70 % RH, non-condensingDimensions (W / H / D) Approx. 560 mm × 190 mm × 224 mmWeight Approx. 3.8 k gApprovals FCC, CE, RoHSCertifications DIN EN 50130-4Safety instructions► Observe the ratings!► Do not open the devices!► Avoid the intrusion of dirt and liquids!► Do not use any force!Connection AssignmentConnection and CommissioningDimensionsConnection System► Connect the modules with the main module.► Connect the monitor with the main module.► Connect the main module to the PC (hot plug).► Connect the main module to the power supply.The VMC-1 starts automatically and is ready for use after a few seconds.CommissioningThe operating system detects the new device automatically.► Note the appropriate messages of the operating system.► Follow the instructions given by the operating system.► Finish the installation of the USB driver.The VMC-1 is ready for operation with a CCTV system.► Note the appropriate documentation of the CCTV system.The following technical data was valid at the time of the document compilation.Refer to www.dallmeier.com for possible updates.Unit: mm22431255819012863ABCJog-ShuttleABCJoystick MonitorCDMain module /Keyboard JE F G HIA Cable interlockB Cable conduitC USB socket, type BD Power IN 12 V DC (from main module)E Microphone INF Power IN 12 V DCG Power OUT 12 V DC (monitor)H USB socket, type B (PC)I 4× USB socket, type A (modules and monitor)J 8× cable conduitABC C C CConnection Monitor► Put the monitor hinges into the mounting plates (A, B).► Fasten the monitor with the screws (C).► Connect the power cable with the monitor.► Connect a USB cable with the monitor.