THUMB TURNASSEMBLYLATCH MOUNTING PLATELATCHDEADBOLTSTRIKEWOOD FRAMEREINFORCERDUST BOXMOUNTING SCREWSFOR USE ON DOORS 1-3/8" to 1-3/4"(35mm-45mm) THICKTOOLS REQUIRED FOR NEW INSTALLATION:(1) Phillips Head Screwdriver(1) 2-1/8" (54mm) Hole Saw(1) 1" (25.4mm) Drill Bit(1) ChiselTOOLS REQUIRED FOR REPLACEMENT INSTALLATION:(1) Phillips Head ScrewdriverFOR REMODELING OR NEW CONSTRUCTION:- Follow all steps3221 Thumbturn Only DeadboltInstallation InstructionsFOLD HEREON DOOR EDGE1-3/8"35451-3/4"T E MP L A T E1-9/16"40CAUTION:DO NOT DRILL 2-1/8" (54mm) HOLETHROUGH TO OPPOSITE SIDE OF DOOR.(READ INSTRUCTIONS CAREFULLY)2-1/8" (5 mm) HOLE4Make 1"(25.4mm) hole at centerof door edge.2-3/8" ( 60mm ) BACKSET2-3/4" ( 70mm ) BACKSET1. MARK DOOR 2. DRILL HOLES3. PREP DOOR2-1/8" (54mm) HOLE1-3/16" (31mm) DEEP1"(25.4mm) HOLE4-1/8"(105mm)DEEPDOOR FACEDOOR EDGE2-1/8" (54mm) HOLE1-3/16" (31mm) DEEP1"(25.4mm) HOLE4-1/8"(105mm)DEEPDOOR FACEDOOR EDGE2-1/8" (54mm) HOLE1-3/16" (31mm) DEEP1"(25.4mm) HOLE4-1/8"(105mm)DEEPDOOR FACEDOOR EDGE2-1/8" (54mm) HOLE1-3/16" (31mm) DEEP1"(25.4mm) HOLE4-1/8"(105mm)DEEPDOOR FACEDOOR EDGEMeasure center line of lock; height as desired from finished floor.Select 2-3/4" or optional 2-3/8" backset, fold and apply templateto interior side of door and mark center of door as indicated ontemplate. Mark center hole on door face through guide on template.(See Step 7 for changing latch backset)Drill 1" (25.4 mm) hole 4-1/8" (105 mm) deep in center of door edge.Drill 2-1/8" (54mm) hole 1-3/16" (31 mm) deep on interior door face.CAUTION:Do not drill completely through the door face.Insert latch in hole, keeping latch face parallel toface of door edge.Mark outline and remove latch.Chisel 5/32" (4 mm) deep oruntil latch face is flush with door edge.Refer to Step 5 & 6 when installing latch.a. b. c.TEMPLATE7/28/08HAGER COMPANIES139 Victor Street, St. Louis, MO 63104 (800) 325-9995 FAX (800) 782-0149