hager REQ5 X Series Manual

hager REQ5 X Series Manual Manual pdf 1 page image

116LE000719AREQ5..X, REQ6..XDoor station VIDEO 2-wirezzSafety instructionsElectrical equipment may only be installed andassembled by a qualified electrician in accor-dance with the relevant installation standards,guidelines, regulations, directives, safety andaccident prevention regulations of the country.When installing and laying cables, always com-ply with the applicable regulations and stan-dards for SELV electrical circuits.These instructions are an integral componentof the product and must be retained by the enduser.Design and layout of the device(7)(3)(6)(4)(5)(2)(1)Figure 1: Front(1) Front plate stainless steel(2) Microphone(3) Camera(4) Locating screw for camera(Allen key supplied)(5) Twilight sensor for call button/loudspeaker(6) Button panel with call push-buttons(7) Cover strip for dismantling protection(11)(8)(9)(10)(12)(13)Figure 2: Back(8) Adjustment button Upwards(9) 7-segment display(10) Selection button(11) Adjustment button downwards(12) Module connecting cable(13) Connection terminal blockFunctionThe door station video works in the 2-wire bussystem and enables communication via sound andimage.Correct use- for surface- or fl ush-mounted installation in spe-cial housings (see Accessories)- Not compatible with intercom systems of othermanufacturers- suitable for use exterior applicationsProduct characteristics- completely pre-assembled- protected against vandalism- with brushed 2 mm stainless steel front plate- Name plate can be changed from the front wit-hout any special tools- One-man commissioning- Call push-button with acknowledge tone (canbe switched off) and tactile feedback- Call button, light release or door release can beadjusted even without any function- durable, homogeneous, white LED call push-button backlighting- Twilight controlled call push-button backlightingwith adjustable switch-on brightness level- Opening of door station only with enclosed ope-ning tool- break-proof flush-mounted call buttons- Colour camera- invisible, glare-free IR LED night lighting- temperature controlled camera heating for clearview- scratch-proof camera cover- Loudspeaker and microphone protected againstsabotage- Volume and microphone sensitivity settable- Door release contact on 1 ... 10 s adjustable- Door release without previous call adjustable insingle door systems- Safety rope as installation aidOperationEstablish call (ringing) Press the call push-button assigned to thedesired subscriber.If configured, the call push-button activation isconfirmed by an acknowledge tone. Addressedindoor stations are called.Switch-on lightsA call push-button is configured and labelled forlighting control (light insert supplied). Press the call push-button for lighting.If configured, the call push-button activation isconfirmed by an acknowledge tone. The lightcontact of a line power supply is closed for theset time.Label call push-button Keep call push-button pressed on one side.On the opposite side, the lever opening (14) isaccessible for a screwdriver. Position the screwdriver in the lever opening(14) and release the interlock (Figure 3). Remove cover with name plate insert.