hager TRM702AU Manual
In1 In2TRM702A433.5 MHz 10 mWIP30cfg3,5maxIn1 In2433.5- The device is to be installed only by aqualified electrician in accordance withthe installation standards in force in thecountry.- Cut off the 230V power supply beforeconnecting the device.The flush-mounting input module TRM702AU is aquicklink radio transmitter. Powered by battery,it can be used to interface 2 floating contacts(switches, automatic-control contacts or intrusionalarm panel contacts) which can thus be renderedcommunicating. quicklink radio products can beconfigured together and operated within the sameradio installation.Caption1 Pushbutton or standard switch2 Connector with inputs connection wires(length 11 cm)3 1 Battery 3V CR2430 (delivered non-assembled)4 Battery enclosure5 Pushbutton and configuration LED RODo not cut the black color antenna wire and theinput wires, even if they are not used.Features• 2 independent input channels.• Supply by battery.Operation of LED• LED flickers for 1s when pressed : the product isnot configured.• LED goes on for 100ms after pressing: input isconfigured, control is transmitted.• LED flickers quickly for 1s after pressing: batteryis low.• LED remains off: the battery level is too low.Wiring, test and start-upThe modules are installed in a flush-mounting boxof 60mm diameter in association with a push-buttonor a switch.Depth will depend on the type of equipment used.The length of connection shall not exceed 10m.Wire not used shall be isolated.Factory ResetMaintain R pushbutton down until LED cfg flickers(>10s), then release. cfg LED turns OFF to signalFactory Reset end. This operation removes the entireproduct configuration in any configuration mode.After power switch-On or Factory Reset, wait for15s before to do a new configuration.Change of batteryBattery 3 is placed under cover 4.Battery change has no influence on the productconfiguration.OThese instructions for use form an integral partof the product and must be retained by the enduser.In1 In2cfg433.5Radio transmitter flush-mounted withbattery 2 inputszTechnical characteristicsSupply voltage 3 V CR 2430Battery operating lifewith 10 manoeuvresper dayPushbutton control > 5 yearsControlled by switchor temperature < 0 °C > 3 yearsTransmissionfrequency/ Emissionpower433,05 - 434,79 MHz10 mWDimensions 41 x 39.5 x 11 mmMax. connectiondistance per input < 10 mMinimum contactsclosing time 50 msOperating temperature -10 °C —> + 50 °CStorage temperature - 25 °C —> + 70 °CDegree of protection IP 30Receiver category 2 / Transmitter duty cycle<10%6LE005080D6LE005080D1TRM702AUMetal surfaces in the direct vicinity of theproduct (e.g. flush mounted metal boxes)may reduce the radio range. If necessary,change the position of the product in thewall box to improve the range.Avoid the use of a metal front plate forswitches in combination with flush mountedmetal boxes. Hager Controls hereby declares that the radiotransmitter/receiver complies with the 2014/53/EU directive.The CE declaration can be consultedon the site:www.hager.comå andComplies withIMDA StandardsDA101847 |
Related manuals for hager TRM702AU
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine