iZ Technology RADAR Support Technical Memo
Also see for RADAR: Operator's manual
      |
iZ Technology Corporation 1i Z S U P P O R T T E C H N I C A L M E M OMOTHERBOARD BATTERYREPLACEMENT PROCEDURE _____________________Always follow proper anti-static precautions when handling internal components onRADAR. iZ recommends performing tasks in an controlled anti-static environment usingan anti-static bracelet connected to the ground of the power switch (or any non-paintedgrounded RADAR chassis metal) when any contact will be made with the inside ofRADAR.SYMPTOMS ___________________________________________Symptoms of motherboard battery on RADAR that should be replaced:The motherboard battery is responsible for powering the real-time clock circuitry that is responsible for thestorage of the CMOS settings in the motherboard’s BIOS setup. If the battery no longer supplies poweryour RADAR may exhibit the following symptoms:• Incorrect system date and time• When booting up the RADAR the video monitor displays “System boot failure”• When booting up the RADAR the video monitor “NTLDR is Missing”• When booting up the RADAR the video monitor “CMOS Checksum Error”• RADAR does not output time code and other problems related to the Sync Processor boardTOOLS REQUIRED _____________________________________You will need the following tools to replace the motherboard battery• Phillips screwdriver• Small flathead jewel screwdriver• Replacement motherboard battery - CR2032 coin type 3V lithium battery |
Related manuals for iZ Technology RADAR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine