jablotron JK-84 Oasis Installation Manual

Also see for JK-84 Oasis: Quick start guide

Contents

programming the system

jablotron JK-84 Oasis Installation Manual Manual pdf 1 page image

The JK-84 “Oasis” wireless alarm kit 1 / 2 MKE59904The JK-84 “Oasis” wireless alarm kitInstallation of the JK-84 kit shall only be undertaken by techniciansholding a certificate issued by an authorized distributor. This simplifiedinstallation manual only describes the basics, for more details see themanuals of particular devices.1. Factory-default pre-enrolled devicesAddress Device Note05 JA-83M door detector Delayed reaction06 JA-83P PIR detector Delayed reaction48 RC-86 keyfob Buttons and pre-enrolled49 JA-81F keypad unit Connect a magnetic door sensorto its IN input.50 JA-80L indoor sirenJA-82KR Pre-enrolled to the JA-80L2. Control panel and keypad installation1. Attach the Control Panel (CP) to the desired location.2. Connect back-up battery to the CP (attach it securely withadhesive tape).3. Connect the mains to the CP – its green LED will start flashing4. Connect up the batteries in the JA-81F keypad – service modeshould be displayed (if not, disconnect the keypad batteries, checkthat the control panel is powered up and reconnect the keypadbatteries).The internal keypad menu can be entered in Service mode byholding the ? key. Using the arrows on keys 1 and 7 you can scrollthought this menu:Display Key DescriptionTamper ON Disable / Enable the tamper sensor(only for service purposes)Door chime ON Disable / Enable sound when IN triggeredBeeper ON Disable / Enable system soundsBrightness Sets the display brightness 0 - 9Contrast Sets the display contrast 0 - 9Edit text Entry to keypads text editingEnglish Sets English (reload default texts)To exit the menu, press # (exiting also occurs after 10 seconds’ inactivity)o If you exit Service mode accidentally, it can be re-entered bykeying in ∗∗∗∗ 0 8080.o Close the keypad’s flip cover to save the battery while in theservice mode.Before attaching the JA-81F keypad, test that it functions correctly atthe desired location. We recommended wiring up a magnetic doorsensor (provided with the kit) to the keypad’s IN input. This will ensurethat the keypad is “woken up” whenever the door is opened (to indicatesystem status, to make entrance delay beeps and to have the accesscard reader ready for reading cards).3. Installing the detectors and the siren1. Install the JA-83M magnetic detector, select its reaction via theinternal DIP switch (INS/DEL), connect its battery up and close thecover.2. Install the JA-83P PIR motion detector about 2 to 2.5 meters abovethe floor, select its reaction via the relevant internal DIP switch(INS/DEL), connect its battery and close the cover.3. Plug the JA-80L siren into a mains power socket.B A B+B A Breed contacttamperINSTANTDELAYserial numberbattery CR123A12 3456789123Main boardTransformerBack-up batteryMains terminalDigital bus connectorTamper switchLEDAntenna connection0102COM0304EWIWPGXPGYGND A B+URESET1 2 3 4ONOFFRadio moduleAntenna12V 2,4Ah

/ 2

Related manuals for jablotron JK-84 Oasis