norbar EVOTORQUE 2 Quick Reference Manual

Also see for EVOTORQUE 2: Operator's manual

norbar EVOTORQUE 2 Quick Reference Manual Manual pdf 1 page image

www.norbar.comIMPORTANT: IT IS VITAL THAT THE SAFETY INFORMATION ON PAGES 3-5 OF THEOPERATOR’S MANUAL (34426) HAS BEEN READ AND FULLYUNDERSTOOD BEFORE USING THIS TOOL.The instructions below are a brief guide for reference only, do not operate the tool before you haveread and understood the Operator’s Manual supplied with the tool.1. Ensure that the correct socket has been fitted to the tool. To fit a socket, firstslide the socket over the tools square drive ensuring the sockets pin hole andthe square drive pin hole line up. Then slot the holding pin through the holeand place the retaining ring over the holding pin to secure.2. Ensure the Clockwise/Counter-clockwise display arrow shown on screen is correct.Press to change direction (if required).3. Ensure Torque, Torque & Angle or Audit Torque target shown is correct. Target will beremembered from the last use.To quickly alter the target shown press and hold either the up or down arrows andpress to confirm; repeat for angle if an angle target is present.To change targets press the button to exit the run screen and bring up the below menu.Then select the targets icon (highlighted above) and press to confirm.Use the up and down arrow keys to highlight required target and press toenter target setup.Alter the targets value using the up and down arrows and confirm by pressing .QUICK REFERENCE GUIDEEVOTORQUE® 2Part Number 34425 | Issue 1 | Original Instructions (English)

/ 2

Related manuals for norbar EVOTORQUE 2