1©2020 Nystrom, Inc.REV 9/2020Installation, Operation+ Maintenance Manual5-1/2" CRASH RESISTANT HANDRAILModel(s):HRVE55C/HRVE55C-TG/HRVE55C-ASGENERAL DESCRIPTIONNystrom's Standard 5-1/2” Handrail is constructed to withstandimpact with built-in crash protection. The sturdy mounting bracketsmaintain wall clearance and stability while providing support inmedium- to high-impact areas. End and corner caps are available assemi-rigid plastic. Optional reveals, available for both foam cushionand semi-rigid plastic end and corner caps, provide additional designoptions.Introduction + SafetyPlease read the complete instructions carefully before beginning any work. To ensure properinstallation and performance of the Expansion Joint, the following actions must be completedby the installing contractor. Failure to do so will affect product warranty.Transportation + Storageo Inspect all shipments and materials for missing or damaged components and hardware.o Material must be stored in a clean, dry location.INSTALLATION1. Lay out the work to be completed, including all component parts, along the base of the wall. Check thematerial for any damage that may have occurred during shipment and/or handling at the job site.2. Snap a chalk line at the proper location on the wall to ensure a level installation. Chalk line should becalculated to the center line of the mounting bracket wall fasteners.GENERAL SAFETY PRECAUTIONS Improper selection, installation, or use can cause personal injury or property damage. Itis solely the responsibility of the user, through its own analysis to select products suitable for their specific applicationrequirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,state and federal regulations for proper installation and operation requirements.