unios Diamond Instruction Manual
  |
FOR WARRANTY INFORMATION VISIT UNIOS.COM/WARRANTYPlease read these installation instructions carefully before installing this luminaire. The luminaire is designed for installation in accordance with relevantAustralian Standards (AS/NSZ 3000). Installation of this luminaire must comply with local regulations. If luminaire is not installed according to theinstructions, the warranty for the luminaire may be void.ENQUIRIES+61 8 9248 1888sales@unios.comDiamond FLOODLIGHTPower10 | 30 | 50 | 70| 100 | 150 | 200 WattsMaterialAluminiumWarranty5 YearsIP Rating65unios.comClass I220–240V ~ 50/60HzFCAUTION – Must Be Installed By A Licensed Electrician Please read instruction manual on both sides carefully before installing luminaire.• This luminaire is void of warranty if any part has been modified.Please visit unios.com/warranty for more information.• Over-voltage protection units should be installed to prevent electroniccontrol gear from failing due to electrical spikes, e.g. from switching ofinductive loads.• Please read instructions for installation of luminaire provided below.Safety of this luminaire and warranty will be voided unless followed.• Installation and operation of this luminaire must be withinaccordance with national safety regulations. Unios™ does not warrantany liability when damage is caused by misuse or improper installation.1ABInstallation Instructions32Must be installed by a licensed electrician.Before installing, make sure the power supply is switched off.Follow the steps in the figure shown for installation:A. Adjust luminaire to allow flexible mounting plate access byusing the hex key as show in Figure A1.B. Fix the mounting plate onto the surface with appropriatefasteners.C. Once fixed, ensure that the heatsink is at least at a 30degree angle above the horizontal plane and 25mm awayfrom any object before re-tightening the hex key.D. Cable supplied must be connected to mains power inaccordance with all relevant standards.Note: After completing above steps, ensure the luminaire isfirmly fixed to the mounting plate. The luminaire must becleaned following these installation instructions. Termination ofwiring and installation of the product shall be conducted suchthat the luminaire’s stated IP rating is not affected.Mounting PlateEdition 3.5.17 | Product design and technical data may be subject to changeDEBCD10W Model30W Model50W Model70W Model100W Model150W Model200W ModelModel A124 17 50 20185214259259320350303535404090110110125125303030404025 70 30B C D810101010108E813131313138FA |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine