veinview MT6103iP series Installation Instruction
Contents |
Installation and Startup GuideThis document covers the installation of MT6103iP Series HMI, for the detailed specifications and operation,please refer to Brochure and EasyBuilder Pro User Manual.Install Environment:NEMA Rating MT6103iP Series HMI is NEMA 4 rated (Indoor Only).ElectricalEnvironmentMT6103iP Series has been tested to conform to European CE requirements. Thismeans that the circuitry is designed to resist the effects of electrical noise. Thisdoes not guarantee noise immunity in severe cases. Proper wire routing andgrounding will insure proper operation.EnvironmentalConsiderations(1) Make sure that the displays are installed correctly and that the operatinglimits are followed. Avoid installing units in environments where severemechanical vibration or shocks are present.(2) Do not operate the unit in areas subject to explosion hazards due toflammable gases, vapors or dusts.(3) Do not install the unit where acid gas, such as SO2 exists.(4) This device should be mounted in the vertical position and for use on the flatsurface enclosure.(5) Conform to UL508 (ISBN 0-7629-0404-6) machine safety for use inPollution Degree 2 Environment.Unpacking the UnitUnpack and check the delivery. If damage is found,notify the supplier.Installation InstructionsSecure the operator panel in position, using all the fastening holes and the provided bracketsand screws. Screw Torque: 2.6 ~ 3.9 lbf.in. (For reaching waterproof effect and preventing the panel frombeing deformed.)Type A(mm) B(mm)MT6103iP 260 202Power ConnectionsSystem SettingsWhen HMI is powered up and displays image,click the system setting button.(Default System Password: 111111)MT6103iP seriesInstallation Instruction12 NOTE:Place the operator panel on a stablesurface during installation. Dropping it orletting it fall may cause damage.35Go to the Security tab, the defaultpassword is 111111, click the buttons toset your own passwords.4 NOTE:1. Connect positive DC line to the ‘+’ terminaland the DC ground to the ‘-’ terminal.2. Please do not connect HMI with PLC and PCsimultaneously to prevent potential differencefrom destroying USB ports of HMI and PC.(A)(B) Cutout(1)(2)(5)(4)(3)(1) Installation Instruction, 2-sided A4 *1(2) Human Machine Interface *1(3) Power Connector *1(4) Brackets & Screws *1 pack(5) Fuse 1.25A/250V 5*20mm *1 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine