u-blox C94-M8P manuals
C94-M8P
Table of contents
- Preface
- Table Of Contents
- Table Of Contents
- Introduction
- Specification
- Getting started
- Hardware installation
- Configuration
- Base station operation
- Configuring RTCM messages
- NEO-M8P UART settings for the Base
- NEO-M8P UART settings for the Rover
- NEO-M8P UART settings for Base
- Navigation rates supported with moving baseline operation
- Rover with moving baseline
- Operation
- Moving baseline mode
- Rover in operation
- Monitoring the quality of the RTCM stream
- Moving baseline
- Evaluation interfaces
- Battery connector
- GNSS antenna connector
- Block diagram
- Board layout
- Schematic
- Appendix
- B.1 Serial console terminal installation
- C Updating C94 radio modem firmware
- C.1 Updating procedure
- D Notes on FW3.01 HPG1.40
- E.2 For C94 radio firmware that is current production low latency firmware as indicated in Table 9
- E.3.3 Dimensions
- F Hardware modification
- Related documents
- Contact
manualsdatabase
Your AI-powered manual search engine