National Instruments ENET-485 Series manuals
ENET-485 Series
Table of contents
- Table Of Contents
- important information
- Table Of Contents
- Table Of Contents
- Table Of Contents
- about this manual
- related documentation
- How to Use This Manual
- What You Need to Get Started
- Serial Device Server Overview
- LED Overview
- Serial Server Software Overview
- Linux x86/Solaris 2.x
- Installing the Serial Server Software
- Installing the Serial Device Server
- Step 3. Connect the Cables
- Step 4. Switch on Your Serial Device Server
- Entering Network Configuration Mode
- Using NI Ethernet Device Configuration
- Configuring the Network Settings
- Static IP Parameters
- Verifying the Hostname
- Adding a New Serial Interface
- COM Port Number
- Running Diagnostics
- Connecting Serial Devices
- General Programming Requirements
- Using DHCP
- Using the CFG RESET Switch
- Using the CFG RESET Switch at Power-On
- Updating the Firmware
- Windows 2000/NT 4.0
- Four-Wire Mode
- Setting the Transceiver Control Mode
- Controlling the Transceiver Mode Programmatically
- Changing the Bias Resistors on the ENET-485
- Changing Bias Resistors
- cable connections
- specifications
- physical characteristics
Related products
ENET-232 SeriesE SeriesR Series651 SeriesCAN Series800 SeriesNI 785 R Series8330 SeriesGPIB SeriesDAQ PCI E SeriesNational Instruments categories
I/O Systems
Control Unit
Computer Hardware
Controller
Measuring Instruments
PCI Card
Data Loggers
Network Hardware
Test Equipment
Recording Equipment
manualsdatabase
Your AI-powered manual search engine