National Instruments GPIB-232CV-A manuals
GPIB-232CV-A
Table of contents
- user manual
- Table Of Contents
- Table Of Contents
- Table Of Contents
- about this manual
- related documentation
- GPIB-232CV-A Overview
- What You Need to Get Started
- Inspection
- Top Panel
- Rear Panel
- Side Panels
- RS-232 Connector
- GPIB Connector
- Configure Your Hardware
- Configure the GPIB-232CV-A Parameters
- Table 2-2. Configuration Parameters for SW1 Switches 6 and 7
- Configure the Serial Port Parameters
- Install Your Hardware
- Step 2. Verify That You Have a Null-Modem Serial Cable
- Step 4. Power on Your System and Switch on Your GPIB-232CV-A
- Choosing Between D Mode and C Mode Configuration
- Figure 3-1. Example of D Mode System Setup
- D Mode Overview
- Choosing a Serial Port Buffer Size
- Conditions That Cause SRQ to be Asserted
- GPIB-232CV-A Serial Poll Responses
- C Mode Overview
- Modes of Operation Within C Mode
- CR> or <LF> Termination Mode
- No-Swap Mode
- Data Buffering and Handshaking Schemes
- XON/XOFF Software Handshaking
- specifications
- physical characteristics
- Figure B-1. Location of the RS-232 Connector
- Figure B-2. Cable Configuration for 9-pin DTE to 9-pin DCE with Handshaking
- Figure B-4. Minimum Configuration for 9-pin DTE to 9-pin DCE
- Figure B-6. Cable Configuration for 9-pin DTE to 9-pin DTE with Handshaking
- Figure B-8. Minimum Configuration for 9-pin DTE to 9-pin DTE
- Figure C-1. Example of Print Spooler Setup
- Germany 089 741 31 30, Greece 30 1 42 96 427, Hong Kong 2645 3186, India
Related products
GPIB-232CVGPIB-422CVGPIB-RS232GPIB-PRLNI GPIB-RS232GPIB-RS485GPIB-RS422NI GPIB-RS485/RS422NI 6224NI 6221National Instruments categories
I/O Systems
Control Unit
Computer Hardware
Controller
Measuring Instruments
PCI Card
Data Loggers
Network Hardware
Test Equipment
Recording Equipment
manualsdatabase
Your AI-powered manual search engine