IBM NetVista N2800e manuals
NetVista N2800e
Table of contents
- Table Of Contents
- safety notices
- about this book
- Express
- Learning about the hardware
- Communication hardware
- Setting up the hardware
- Startup sequence
- Configuring the N2800e Thin Client Express
- Using the Configuration Tool to configure the workstation
- Installing the Thin Client Service Utility and the Operations Utilities
- Installing the utilities from the NetVista Thin Client Utilities CD
- Managing your Thin Client Express remotely
- PPP dialer for Thin Client Express workstations
- Configuring initial modem settings for PPP dialer access
- Starting the PPP dialer
- Using the PPP dialer to access flash images
- Copyright IBM Corp
- Using the Thin Client Manager Operations Utility to perform a software update on a workstation
- Using one workstation to recover the flash image of another workstation
- Using the Setup Utility to recover the flash image of a workstation
- Using the Thin Client Manager Operations Utility to recover the flash image of a workstation
- Resolving hardware problems
- Visible hardware failure
- Audio beep sequences
- LED indications
- Error codes and text messages
- Appendix A. Replacing hardware parts
- Replacing parts other than the N2800e CompactFlash card
- Returning hardware parts
- Appendix B. Hardware maintenance procedures
- Appendix C. Setting the thin client voltage for your location
- Appendix D. Recovering the boot block image
- Appendix E. Choosing a flash file
- Appendix F. Monitor specifications
- Appendix G. Connector pin information
- Notices
- Environmental Design
- Trademarks
- Glossary of abbreviations
- Index
manualsdatabase
Your AI-powered manual search engine