ABB RES670 2.1 manuals
RES670 2.1
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- section 1 introduction
- Product documentation
- Document revision history
- Related documents
- Document conventions
- IEC61850 edition 1 / edition 2 mapping
- safety information
- Caution signs
- Note signs
- Section 3 Available functions
- Control and monitoring functions
- Communication
- Basic IED functions
- Section 4 Starting up
- Checking the power supply
- IED start-up sequence
- Writing an application configuration to the IED
- Checking CT circuits
- Checking VT circuits
- Checking the binary I/O circuits
- Binary output circuits
- Section 5 Configuring the IED and changing settings
- Configuring analog CT inputs
- Section 6 Establishing connection and verifying the SPA/IEC communication
- Verifying the communication
- Fibre optic loop
- Section 7 Establishing connection and verifying the LON communication
- The LON Protocol
- Optical budget calculation for serial communication with LON
- Section 8 Establishing connection and verifying the IEC
- Section 9 Establishing connection and verifying the IEEE C37.118/1344 communication
- Setting the PMU station communication (PMU configuration)
- Setting the TCP/UDP client communication
- Verifying the IEEE C37.118/1344 TCP communication
- Verifying the IEEE C37.118/1344 UDP communication
- Optical budget calculation for RES670 - PDC communication
- Preparing for test
- Preparing the IED to verify settings
- Activating the test mode
- Connecting the test equipment to the IED
- Releasing the function to be tested
- Verifying analog primary and secondary measurement
- Testing the protection functionality
- Forcing of binary I/O signals for testing
- Enable forcing using TESTMODE function block
- Forcing by using PCM600
- How to undo forcing changes and return the IED to normal operation
- Undo forcing by using PCM600
- Testing disturbance report
- Event recorder (ER) and Event list (EL)
- Identifying the function to test in the technical reference manual
- Verifying the settings
- Testing the power swing detection function ZMRPSB (68)
- or FRPSPDIS (21) and ZMRPSB (78)
- Current protection
- Completing the test
- Four step non-directional ground fault protection
- Measuring the trip and time limit for set values
- Two step overvoltage protection OV2PTOV (59)
- Built-in overcurrent feature (non-directional)
- Overcurrent feature with current restraint
- Over/Undervoltage feature
- Measuring the trip value for the negative sequence function
- Measuring the trip value for the zero-sequence function
- Checking the operation of the dv/dt and di/dt based function
- Logic
- ph/2ph/3ph operating mode
- Circuit breaker lockout
- Metering
- Station communication
- clearing system
- Visual inspection
- Preparation
- Self supervision check
- Restoring
- troubleshooting
- Communication Diagnostics
- Fault tracing
- Using front-connected PC
- Repair instruction
- Repair support
- Section 14 Glossary
Related products
Relion RES670Relion RES670 A20Relion RES670 B20VLMD-1-2-RRelion 670 Series RES670VLMD-1-2Relion 670 seriesAMTD-2-R PAMTD-1-R PRelionABB categories
Industrial Equipment
DC Drives
Controller
Relays
Measuring Instruments
Circuit breakers
Battery Charger
Industrial Electrical
Transformer
Switch
manualsdatabase
Your AI-powered manual search engine