Campbell TurfWeather manuals
TurfWeather
Table of contents
- Table Of Contents
- Quick Start Guide
- serial cable male connector connects. A dust cover must be removed from the weather station RS-232 port before connecting the cable
- Keyed power switch is located on the bottom of the weather station
- Radio Setup
- Help and Support
- Communications Considerations
- Grounding Issues
- Testing Radio Transmissions
- Installation Procedures
- Procedure 1b: Ground Installations
- Procedure 2: 16772 Guy-Wire Kit Installation
- Procedure 3: Mounting the TurfWeather Station on a Tripod or Pole
- Two views of the TurfWeather station. The U-bolt and nuts are shown
- Procedure 4: SP5 Solar Panel Installation
- Procedure 5: 16775 Ground Kit Installation
- The right close up is the 14 AWG wire and the #4 cable attached to the tripod coupling
- Procedure 6: Base Radio and standard antenna installation
- Procedure 7: 17342 Short-Haul Modem installation
- The Short Haul Enclosure Mounted
- The Cables Connected to Enclosure
- Maintenance
- Rain Gauge P/N 25585
- High Gain Base Station Antenna Installation Procedure
- Battery Pack (P/N 14159) Removal and Replacement Procedure
- Temperature/Relative Humidity Sensor Assembly (P/N
- Procedure
- Rain Gauge (P/N 25585) Removal and Replacement Procedure
- Wind Speed Sensor (Anemometer) (P/N 14010) Removal and Replacement Procedure
- Wind Direction Sensor (P/N 14011) Removal and Replacement Procedure
- Memory Battery (P/N 15598) Removal and Replacement Procedure
- Main Electronics Board (Motherboard) Removal and Replacement Procedure
- Spread Spectrum Radio (all frequencies) Removal and Replacement Procedure
manualsdatabase
Your AI-powered manual search engine