40 41DVR: Setup (Alarm)DVR: Setup (Alarm)You can use your remote control within the detection area to select twopoints as a diagonal to define a detection area. Within the user definedarea, when there is an object moving, the system will give an alarm whenit is detected. A user can search motion detection alarm events under“Configuration Log Search”, naming “CHL MD alarm”.How to Set a Detection Area:1. Select “Setup”, and press the “Enter” button on the remote to enterthe motion detection setting interface.2. Select the first block (yellow), and then the motion block will changeto blue after you press the “Enter” button confirming its placement.3. Select the second block and press the “Enter” button. The rectangulararea formed by the diagonal of these two blocks is shown.4. Press “Return” to return to the previous menu and press the “Save”button.Step 5: Temperature Setup (NOT currently used) Step 6: Motion Detection Setup (NOT currently used)Environmental changesmay be detectedmore easily when thesensitivity is set high;however, change ofbrightness and colorwill also trigger analarm.FIG. 25Temperature Setup InterfaceFIG. 26Motion Detection Setup Interface