2N Helios IP User Manual
Also see for Helios IP: Configuration manualUser manualInstallation manualInstallation manualInstallation manual
                                                                                                                       | |
Contents
| 
Mounting - Completion 2.4352.4 Mounting - Completion1. Remember to seal the 2N® Helios IP cable passage hole properly to avoid moisturein-leak and damage to electronics due to condensation.2. Make sure that the wires inside 2N® Helios IP are not squeezed and insert theplastic top cover (a transparent plastic mould) carefully making its contacts pluginto the electronics board connectors. Push the plastic cover into positionmoderately. If the part swings over an obstacle or one corner is higher than theothers, remove the cover and find the obstacle. Then tighten the corner screwsproperly.3. Mounting the metal sheet cover follow the steps included in the subsectiondedicated to name plate removal. Make sure that the cover fits well and isperfectly flat. If its bottom part is loose, the mounting wall is probably uneven.Support the corners to avoid 2N® Helios IP bending.Caution An improper mounting may significantly deteriorate the button function. A poor outdoor mounting may cause water in-leak and damage to theelectronics.Most Frequent Mounting ErrorsFor illustration, a part of the plastic cover is removed in the figures below to reveal thesealed loudspeaker and the cover–seal touch point. The cross section plane is markedwhite for better orientation.Poorly tightened screw(a squeezed wire has the sameeffect)WRONGGap between plastic cover andloudspeaker seal- water may leak in anddamage electronics |
Related manuals for 2N Helios IP
manualsdatabase
Your AI-powered manual search engine