2gig Technologies GO!CONTROL User Manual

Also see for Go!Control Panel: Installation & programming guide Installation and Programming Technical Training User guide

Contents

2gig Technologies GO!CONTROL User Manual Manual pdf 35 page image

Go!Control Wireless Security System | User Guide34 ©2013 2GIG Technologies Inc. All Rights Reserved.that can chime and the option currentlyset for the sensor.To change the sensor’s chime options,press the sensor button.TIP: There are 14 chime options foreach sensor.7 Check the option that you want for thesensor, then press Ok.8 When you are finished, press Back.Chime Options1 Disabled 8 Ding‐dong with Voice #32 Voice Only 9 Ding‐ding3 Ding‐dong #1 10 Ding‐ding with Voice4 Ding‐dong withVoice #1 11 Chime#15 Ding‐dong #2 12 Chime with Voice #16 Ding‐dong withVoice #2 13 Chime#27 Ding‐dong #3 14 Chime with Voice #2BRIGHTNESS/VOLUMEYou can adjust the brightness of the ControlPanel’s display and the volume of thesystem’s speaker that is best suited to yourinstalled system.To set the brightness and volume, do thefollowing:1 From the Home Screen, press Security.2 From the Security Screen, press Menu.3 From the Menu Screen, press Toolbox.4 Enter the Master User Code to accessthe toolbox.5 From the Toolbox Screen (1 of 3) pressBrightness/Volume. You can set thebrightness using the top bar. Adjust thelevel from 1 to 12 using the buttons oneach end of the bar.6 You can set the speaker volume for thechimes and announcements on thebottom bar. Adjust the level from 1 to 12using the buttons on each end of the bar.7 The volume setting does not effect thealarm sounder volume.8 When you are finished, press Ok.BACKLIGHT TIME-OUTThe backlight time‐out sets the length oftime that the display stays lit after use. Youcan adjust the backlight to 30 seconds, 1, 2,5, or 10 minutes, or to always (to light thedisplay at all times).NOTE: To conserve the Control Panel’sbackup battery, during an AC powerfailure, the display goes dark after 30seconds regardless of this setting.To set the display backlight time, do thefollowing:1 From the Home Screen, press Security.2 From the Security Screen, press Menu.3 From the Menu Screen, press Toolbox.4 To access the toolbox, enter a valid UserCode.5 From Toolbox Screen (1 of 3), press the→ arrow.