3Com 100 TX User Manual

FCC CLASS A VERIFICATION STATEMENTWARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCCRules, and the Canadian Department of Communications Equipment Standards entitled, “Digital Apparatus,” ICES-003. These limits aredesigned to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case, the user will berequired to correct the interference at the user’s own expense.Changes or modifications not expressly approved by 3Com could void the user’s authority to operate this equipment.CISPR A COMPLIANCEThis device complies with the EMC directive of the European Community and meets or exceeds the following technical standard:EN 55022 – Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment.This device complies with the CISPR Class A standard.WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may berequired to take adequate measures.3Com Corporation5400 Bayfront PlazaSanta Clara, CA 95052-8145(408) 764-5000CE NOTICEMarking by the symbol indicates compliance of this equipment to the EMC directive of the European Community. Such marking isindicative that this equipment meets or exceeds the following technical standards:n EN 55022—“Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equiment.”n EN 50082-1—“Electromagnetic compatibility —Generic immunity standard Part 1: Residential, commercial, and light industry.”n IEC 801-2—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 2: Electrostatic dischargerequirements.”—Severity level 3.n IEC 801-3—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 3: Radiated electromagnetic fieldrequirements.”—Severity level 2.n IEC 801-4—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 4: Electrical fast transient/burstrequirements.”—Severity level 2.n A “Declaration of Conformity” in accordance with the above standards has been made and is on file at 3Com Corporation.