3Com 16 Plus User Manual

Also see for 16 Plus: Datasheet

11Stacking the Units TogetherThe Rubber FeetThe four self-adhesive rubber feet prevent your switch frommoving around on your desk. Only stick the feet to themarked areas at each corner of the underside of your switchif you intend to place the unit directly on top of the desk.Do not fix the feet if you are going to use the clip.The Stacking ClipThe stacking clip allows you to stack your OfficeConnectunits together neatly and securely.CAUTION: You can stack up to a maximum of fourunits. Smaller units must be stacked above largerunits.To fit the clip:1 Place your unit on a flat surface.2 Fit the clip across the top of the unit, as shown inFigure 3 (picture 1), ensuring that the longer sections ofthe fastening pieces are pointing downwards.3 Align the fastening pieces over the slots found on eachside of the unit.4 Push the clip down gently to secure it, ensuring thefastening pieces snap into the slots on the unit.To fit another unit:1 Rest the second unit on top of the clip and align it withthe front of the unit below.2 Press down gently on the unit to secure it onto the clip,ensuring the fastening pieces fit into the slots on the unitbelow, as shown in Figure 3 (picture 2).Figure 3 Stacking Your Units TogetherTo remove the clip:1 Remove the top unit together with the clip. If you hooka finger around one of the the fastening pieces and thenpull it gently from out of the slot, the clip should comeaway with the upper unit attached to it.2 Push the clip in the center, so it bends towards the baseof the unit, and then separate once the clip is loose.1FasteningPiece2FasteningPiece