5 Windows NT Driver Setup3811 Click Exit, and then perform the steps outlined in Completing NIC installation withWindows NT screen.12 When prompted to restart your computer, click Yes.The system restarts, using the new configuration settings.13 When the system returns to normal operation, verify that the NIC port LEDs operateas described in “Installing and Connecting the NIC” on page 7.Modifying Configuration ParametersAfter the NIC driver software has been installed, you can change the configurationoptions at any time. The following NIC parameters are user-configurable: Basic properties: Flow Control, Speed and Duplex, and Jumbo MTU. Optional properties: Failover Team Configuration and VLAN Configuration.NICs configured as part of a failover share basic configuration properties. Changing theconfiguration of one NIC in a specific team changes the properties of all the NICs inthat team.To access the NIC properties:1 Open the Control Panel and double-click the Network icon.2 When the Network window opens, select the Adapters tab.The bus and slot number of the highlighted NIC are listed in the lower part ofthe window.NOTE: After installing the drivers, it is recommended that you install the 3ComManagement Programs to make full use of all management features. For moreinformation, see “3Com Management Programs” on page 85.
