3Com 4200G 12-Port Configuration Manual

Also see for 3CR17660-91: Quick reference guide Datasheet

Contents

3Com 4200G 12-Port Configuration Manual Manual pdf 364 page image

350 CHAPTER 39: INFORMATION CENTERDisplaying andDebuggingInformation CenterAfter the performing the above configurations, you can execute the displaycommand in any view to display the running status of the information center, andthus validate your configurations. You can also execute the reset command to clearstatistics on the information center. Make sure to execute the reset commands in theUser View.Information CenterConfigurationExampleLog Output to theConsoleNetwork requirementsThe switch sends the following information to the console: the log information of thetwo modules ARP and IP, with severity higher than “informational”.Network diagramFigure 110 Networking for log output to the consoleConfiguration procedure1 Enable the information center. system-view[4200G] info-center enable2 Enable log information output to the console. Set the severity level threshold toinformational. Permit information output from the ARP and IP modules.[4200G] info-center console channel console[4200G] info-center source arp channel console log level informational[4200G] info-center source ip channel console log level informational3 Enable terminal display. terminal monitorTable 307 Display and debug information centerOperation CommandDisplay the settings of one or all informationchannelsdisplay channel [ channel-number |channel-name ]Display system log settings and memorybuffer record statisticsdisplay info-centerdisplay the status of the log buffer and therecords in the log bufferdisplay logbuffer [ unit unit-id ] [ level severity| size buffersize ]* [ | { begin | exclude |include } regular-expression ]Display summary of the log buffer display logbuffer summary [ level severity ]Display the status of the trap buffer and therecords in the trap bufferdisplay trapbuffer [ unit unit-id ] [ sizebuffersize ]Clear information in the log buffer reset logbuffer [ unit unit-id ]Clear information in the trap buffer. reset trapbuffer [ unit unit-id ]consolePC SwitchconsolePC SwitchconsolePC SwitchconsolePC Switch