3Com Access Builder 7000 User Manual

Contents

Front Panel LEDs 2-9PRI Bridge/RouterCHAN 1 and 2 Channels 1 and 2 show the status of the two WAN ports,WAN1 and WAN2. When lit, the LED shows that WAN port is configuredand up. When flashing, it shows that WAN port is configured and down.ISDN When lit shows that one or more ISDN channels are in use.PRI FOUND Indicates that a PRI Interface Module has been identified inthe chassis.SRC MASTER When lit shows that this module is the SRC master. If theLED is flashing, it indicates a new SRC master is being chosen.SRC SLAVE When lit shows that this module is the SRC slave. If the LEDis flashing, it indicates a new SRC master is being chosen.PWR (Power) When lit indicates that the module is receiving powerfrom the chassis’ backplane and that the power circuits are functioningcorrectly.ALARM Lights to indicate that an event has occurred which has beenconfigured to raise an alarm. See the AccessBuilder 7000 AccessConcentrator User Guide for more information.ALERT Lights to indicate that an event has occurred which has beenconfigured to raise an alert. See the AccessBuilder 7000 AccessConcentrator User Guide for more information.TEST Lights during the power-on self test.LAN When lit shows that LAN activity has been detected within the last10 seconds. If the LED flashes, it shows the LAN is connected but noactivity has been detected for 10 seconds or longer.MANAGER When lit, a management terminal is connected to the module.RUN When lit indicates the module’s onboard software is running.Push Buttons Push both buttons together to reset the module andrestart it using the previously saved configuration.