3Com EtherLink 3C985B-SX Installation And User Manual

Also see for EtherLink 3C985B-SX: Installation and user guide User guide

3Com EtherLink 3C985B-SX Installation And User Manual Manual pdf 15 page image

112 Installing theNIC HardwareThe following instructions apply to installing the NIC in most systems. Refer to the manuals that were suppliedwith your system for details about performing these tasks on your particular system.System RequirementsBefore installing the NIC, make sure your system meets the hardware and software requirements listed in thefollowing table:Safety PrecautionsCategory RequirementsHardware Pentium-based computer that meets Novell NetWare 4.2 and 5.15.1 software requirements One open 32-bit or 64-bit PCI slot 128MB RAM (minimum)SoftwareOperating System Novell NetWare 5.1, with the most recent NetWare 5 Support PackNovell NetWare 4.2 with the most recent patches and support available from Novell technical support(http://support.novell.com)NIC Software NIC driver software, version 2.3 (or higher) for Novell NetWare. See the CD-ROM for these files: 3c986.lan (network device driver file) 3c986.ldi (information used by installation program)CAUTION: The NIC is being installed in a system that operates with voltages that can be lethal. Before youremove the cover of your system, you must observe the following precautions to protect yourself and toprevent damage to the system components. Remove any metallic objects or jewelry from your hands and wrists. Make sure to use only insulated or nonconducting tools. Verify that the system is powered OFF and unplugged before accessing internal components. Installation or removal of NICs must be performed in a static-free environment. The use of a properlygrounded wrist strap or other personal anti-static devices and an anti-static mat is stronglyrecommended.