6-8 C HAPTER 6: M ANUAL SETUPn To create a filter to block NetBios file and printer sharing over the Remote Siteconnection, use the following command:add auto_filter vc_blk_netbios vc Where is the VC Remote Site profile name.This command creates a filter which rejects incoming frames with destination UDPports 137 and 138, and destination TCP ports 139 and 143. The filter isautomatically added to the filter manager and attached as the Remote Site’sprofile input filter.Configuring IP RIP for aRemote SiteIP RIP can be enabled or disabled for each remote site connection. TheOfficeConnect Remote 812 supports two versions of RIP, V1 or V2. Additionally,you can configure whether the OfficeConnect Remote 812 should advertise localroutes, only listen for routes from the remote site, or both.n To configure RIP for a remote site connection:set vc ip_routing [BOTH | LISTEN | NONE | SEND]If you are using address translation for a remote site connection (NAT) you mustset ip_routing to LISTEN or NONE. This is because you have set up a private LANnetwork and therefore do not want to be broadcasting information to otherrouters. The OfficeConnect Remote 812 will not allow a profile using addresstranslation to be enabled if ip_routing is set to BOTH or SEND.n To configure the RIP version for the remote site connection use:set vc rip [RIPV1 | RIPV2]Configuring Static andFramed IP RoutesA Static route is a configured route that will remain in the routing table untildeleted. Static routes differ from Dynamic routes in that Dynamic routes arelearned real-time via RIP.A Framed route is much like a Static route in that you manually configure theroute. The difference is that a Static route is defined for the LAN while a Framedroute is associated with a remote site connection. Also, while a Static route isactive when the LAN is connected, a Framed route is active only when theconnection to the associated remote site is active.If you wish to set up a route to a network on the other side of a remote site, use aFramed route. If you wish to set up a route to a network through the LAN, use aStatic route. Only use Static and Framed routes for networks not learned usingRIP.n To add a Static route over the LAN, use the command:add ip route gateway metric