3Com OfficeConnect Hub 8 User Manual

Also see for OFFICECONNECT ETHERNET HUB 8: Manual User guide User guide User guide Datasheet

Contents

11Stacking the Units TogetherThe Rubber FeetThe four self-adhesive rubber feet prevent your hub frommoving around on your desk. Only stick the feet to themarked areas at each corner of the underside of your hub ifyou intend to place the unit directly on top of the desk. Donot fix the feet if you are going to use the clip.The Stacking ClipThe blue stacking clip allows you to stack yourOfficeConnect units together neatly and securely.CAUTION: You can stack up to a maximum of fourunits. Smaller units must be stacked above largerunits.To fit the clip:1 Place your unit on a flat surface.2 Fit the clip across the top of the unit, as shown inFigure 2 (picture 1), ensuring that the longer sections ofthe fastening pieces are pointing downwards.3 Align the fastening pieces over the slots found on eachside of the unit.4 Push the clip down gently to secure it, ensuring thefastening pieces snap into the slots on the unit.To fit another unit:1 Rest the second unit on top of the clip and align it withthe front of the unit below.2 Press down gently on the unit to secure it onto the clip,ensuring the fastening pieces fit into the slots on the unitbelow, as shown in Figure 2 (picture 2).Figure 2 Stacking Your Units TogetherTo remove the clip:1 Remove the top unit together with the clip. If you hooka finger around one of the the fastening pieces and thenpull it gently from out of the slot, the clip should comeaway with the upper unit attached to it.2 Push the clip in the center, so it bends towards the baseof the unit, and then separate once the clip is loose.1FasteningPiece2FasteningPiece3C16721.book Page 11 Wednesday, July 7, 1999 3:05 PM