3Com Router 3012 Installation Manual

3Com Router 3012 Installation Manual Manual pdf 22 page image

22 CHAPTER 2: INSTALLING THE R OUTER■ Ethernet cable■ Console cable■ AUX cable■ Power supply, power cord, and chassis ground wire■ EquipmentA routerEthernet 10/100BASE-T Hub or LAN switchChannel service unit/data service unit (CSU/DSU) or other data communicationsequipment (DCE) equipment (such as a modem)Configuration terminal, such as a PCMounting the Routeron a Vertical SurfaceThe Router 3000 can be mounted onto a vertical surface using two pan-headscrews aligned to the brackets on the base of the router. To mount the router on avertical surface, do the following:1 Mark the bracket positions on the wall.2 Screw two pan-head screws into the marked positions on the wall or other verticalsurface, so that the screws match the position of the two brackets on the base ofthe router. Each screw should project 0.6 cm (.25 in) from the wall or the surface.3 Make sure that the front panel LEDs are easily visible to the operator.4 Hang the router on the screws by the two brackets.5 Secure the external power supply of the router to prevent the power cords fromdetaching.See Figure 9 and Figure 10 for illustrations of this procedure.Figure 9 The Bottom of the Router120mm4.72in