43WPA Note:The WPA key management must match the settings on the Authentication Page. Whenusing 802.1x, the access point uses session keys provided during the 802.1x EAP keyexchange as the “seed key” for WPA. This is more secure than PSK, since each clientstarts with a unique session key for all subsequent keys generated. Otherwise, the PSKis used for the “seed key”.The 802.1x Wireless Setup on the Authentication Page should be set as follows:• If only one Radio is installed, and “WPA pre-shared key (PSK)” is selected on thesecurity page, then the 802.1x Wireless Setup can be either “Disabled” or“Supported” on the Authentication Page.• If only one Radio is installed and “WPA authentication over 802.1x” is selected onthe security page, then 802.1x Wireless Setup must be either “Supported” or“Required” on the Authentication Page.WEP ConfigurationWEP encryption is based on the use of security keys and the popular RC4 encryptionalgorithm.At least one transmit key must be defined in the WEP Configuration. Wireless deviceswithout a valid WEP key will be excluded from network traffic.The key selected as the transmit key index is used by the access point for alltransmissions. Other keys defined can be used by the access point for decryptingstation communications. When enabling 802.1x security with dynamic session keys,key index 4 is reserved for the 802.1x client session key. Therefore, when 802.1xclients are in the network, the access point should not be configured to use key index 4as the transmit key index.To configure WEP encryption:1 Under Encryption, select Enable.2 Under WEP Configuration, select the Key Size.The access point supports shared key encryption with key lengths of 64-bits,128-bits, or 152-bits.3 Select the Key Type.Hexadecimal (0~9, A~F; for example, D7 0A 9C 7F E5)Alphanumeric (0~9, A~F; for example 01234)3Com Passphrase(a string, described below)4 Enter the keys in their fields.64-bit—Each key contains 10 hexadecimal digits or 5 alphanumeric characters.