3M Industrial Adhesives and Tapes 700r3 Instructions And Parts List
                                                                                                                                              | |
15 2011 November700r3-NA4-SPECIFICATIONSIMPORTANT SAFEGUARD5. Tape Width50mm [2 inch] minimum to 76mm [3 inch] maximum4. TapeScotch® pressure-sensitive fi lm box sealing tapes.3. Operating ConditionsUse in dry, relatively clean environments at 5 o C to 50o C [40o F to 120o F] with clean, dry boxes.Note: Machine should not be washed or subjected to conditions causing moisture condensation oncomponents.• To reduce the risk associated with fLreand explosion hazards:− Do not operate this equipment in poten-tially fl ammable or explosive environments.WARNING1. Power Requirements:Electrical – 115 VAC, 60 Hz, 3.6 APneumatic – 6.5 bar gauge pressure [95 PSIG], 2.5 SCFM75 liter/minute @ 21° C., 1.01 bar maximum at maximum cycle rate.A pressure regulator/filter is included.The machine is equipped with two 1/6 HP gearmotors and comes with an 2.4 m [8 foot] standard neoprenecovered power cord and a grounded plug. Contact your 3M Representative for power requirements not listedabove. Contact your 3M Representative for power requirements not listed above.2. Operating Rate:Belt speed is 0.37m/s [72 F.P.M.]Actual production rate is dependent on operator's dexterity. Boxes must be 18 inches (457mm) apart minimum. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine