3M MP8610 Service Manual
Also see for Multimedia Projector MP8610: Operator's guideService manualService manualQuick setup instructionsQuick start guide
                                                 | |
Contents
| 
3M Multimedia Projector MP8610 Disassembly/Reassembly 3M 1999 2-32134562-3-2. Remove Top CoverTo avoid electrical shocks, unplug projectorpower cord before performing any maintenanceto electrical components.To avoid burns to fingers, allow projector lampand internal projector components to cool off priorto lamp removal or disassembly.Remove the lens cover.1. Remove two (2) screws from the top cover.2. Lower the carrying handle for screw access.3. Remove two (2) screws.4. Pry out the small cap from the top cover hingeassembly.5. Loosen the hinge screw 2 full revolutions.6. Pull out the hinge assembly while pushing against theloosened hinge screw.7. Repeat steps 4, 5, 6 for the top cover hinge assemblyon the other side of the projector.8. Remove the top cover.9. Reassemble in reverse order.! Caution! WARNING |
Related manuals for 3M Multimedia Projector MP8610
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine