3M Multimedia Projector S10 Safety Manual

Also see for Multimedia Projector S10: Quick start guide Specification sheet Operator's guide Operator's guide

3M Multimedia Projector S10 Safety Manual Manual pdf 10 page image

3M™ Multimedia Projector S10 Product Safety Guide © 3M 200310LampLamp Operation:The following symptoms may indicate a lamp in need of replacement:• LAMP indicator lights up red.• “CHANGE THE LAMP” message appears on the screen.• To reduce the risk associated with air or ground water contamination, which ifnot avoided could result in death or serious injury:- The lamp in this product contains mercuy. Dispose of projection lamp in a mannerthat is consistent with your local hazardous waste regulations for mercury.- For recycling and disposal information, contact your respective governmentalagencies.In U.S., contact the Electronic Industries Alliance at www.lamprecycle.orgIn Canada, contact the Electronic Product Stewardship Canada at www.epsc.caWARNINGDisplay Lamp Operation HoursTo determine the lamp operation hours, follow these steps:1. While the projector is running, press the MENU button on the remote control.Choose the “OPTION” using the button.2. The operating time of the lamp will be displayed. The message “CHANGE THE LAMP,AFTER REPLACING LAMP RESET THE LAMP TIMER” will appear after the lampoperating hours have reached the end of the normal lamp life. The message “POWERWILL TURN OFF AFTER 20 HOURS” will appear when 20 or less lamp hours remain.The number of hours left until shut down will decrease until 0 hour is reached, thenpower will be turned off.√ NoteAfter normal lamp operating time has expired, the projector will only run for 10-minuteintervals when restarted until the lamp is replaced and the lamp timer is reset. The message“CHANGE THE LAMP” will blink at projector start up to remind you to change the lamp.Reset Lamp Hours1. While the projector is running, press the MENU button on the remote control.Choose the “OPTION” using the button, and press the button or the ENTERbutton.2. Choose the “LAMP TIMER” using the button, and press and hold the RESET buttonon the remote control for 3 seconds.3. The reset menu will then appear. After you replace the lamp with a new lamp, select“RESET” on the menu with the button.ENGLISH