3M Multimedia Projector X15i Safety Manual

Also see for Multimedia Projector X15i: Brochure & specs Operator's guide Quick start guide Operator's guide

Contents

3M Multimedia Projector X15i Safety Manual Manual pdf 8 page image

3M™ Multimedia Projector X15i Product Safety Guide © 3M 2006ENGLISH Important Note1. Always open the lens shutter or remove lens cap when the projection lamp is on.2. To avoid premature lamp failure, do not change the mounting position of theprojector �desktop ceiling mount or ceiling desktop mount�� and continue to use thesame lamp.�� To avoid red�ced lamp li��e�� do not to�ch projection lamp with �are fin�ers�. To avoid reduced image quality, do not touch projection lens or other internaloptical components.5. Do not use detergents, chemicals, or any spray liquids for cleaning this unit, otherthan those referred to in the “�perators Guide”.6. For maximum lamp life, do not strike or drop, improperly handle, or scratch thelamp glass. Also, do not install an old or used lamp.7� Keep air filter clean� Re��er to the cleanin� instr�ctions contained in the “Operator’sGuide”.. Keep all ventilation openings free of any obstructions.9. In some countries, the line voltage is N�T stable. This projector is designed tooperate safely within a bandwidth of 100 to 120 volts / 220 to 20 volts �50 to 60Hz�� ±10%, but could fail if power drops or surges of ±10 volts occur. In these high-risk areas, it is recommended to install a power stabilizer unit.10. Do not block intake or exhaust air vents. This will cause the projector to over heatand shut down.11. Do not place the projector in direct sunlight or near a hot object such as a heater.12. To prevent damaging the projector, always hold the projector whenever using theelevator buttons to adjust the elevator feet.13. Use the accessory cable or a designated-type cable for the connection. Somecables have to be used with core set. A too long cable may cause certain picturedegradation. Please consult with your dealer for details. For cables that have acore only at one end, connect the core to the projector.1. Make sure that you connect devices to the correct port. Incorrect connection mayresult in malfunction and/or damage to the device and/or projector.15. Do not place the projector in the side/front/rear-up position, except care of the airfilter�