3M SCP715 Operator's Manual
Also see for SCP715: SpecificationsOperator's guide
                                                          | |
Contents
| 
16 © 3M 2008. All Rights Reserved.Installation 3M™ Super Close Projection SystemLED Indicator When the “TEMP” indicator turns red, it indicates theprojector has overheated. The projector will automaticallyshut itself down. When the “LAMP” indicator turns red, it indicates a problemwith the lamp. Turn off the projector and disconnect thepower cord from the electrical outlet, then contact your localdealer or our service center. When the “LAMP” indicator flashes red, it indicates thefan has failed. Stop using the projector and disconnect thepower cord from the electrical outlet, then contact your localdealer or our service center.Powering Off the Projector1. Press the “Power/Standby” button to turn off the projectorlamp; you will see a messagedisplayed on the projecor’s screen. Press the “Power/Standby” button again to confirm.2. The cooling fans continue to operate for about 2 minutes forcooling cycle and the Power LED will flash red. When thePower LED stops flashing, the projector has entered standbymode.Once in standby mode, simply press “Power/Standby” buttonto restart the projector.3. Disconnect the power cord from the electrical outlet and theprojector.4. Following a power off procedure, please allow 2 minutesbefore attempting to restart the projector. |
Related manuals for 3M SCP715
manualsdatabase
Your AI-powered manual search engine