4IPNET HSG1250 Quick Installaion Manual

Also see for HSG1250: User manual Quick installation guide

Contents

4IPNET HSG1250 Quick Installaion Manual Manual pdf 8 page image

Quick Installation GuideHSG260 Wireless Hotspot Gateway ENGLISHCopyright © 4IPNET, INC. All rights reserved. 4Hardware InstallationPlease follow the steps mentioned below to install the hardware of HSG260:1. Place the HSG260 at a best location.The best location for HSG260 is usually at the center of your wireless network.2. To supply power over to HSG260.(a) Connect the DC power adapter to the HSG260 power socket on the front panel.Please only use the power adapter supplied with the HSG260package. Using a different power adapter may damage thissystem.3. Connect HSG260 to your outbound network device.Connect one end of the Ethernet cable to the WAN port of HSG260 on the rear panel.Depending on the type of Internet service provided by your ISP, connect the other endof the cable to the ATU-Router of an ADSL, a cable modem, a switch or a hub. TheWAN LED indicator should be ON to indicate a proper connection.4. Connect HSG260 to your network device.Connect one end of the Ethernet cable to the LAN1 port of HSG260 on the rear panel.Connect the other end of the cable to a PC for configuring the system. The LAN1 LEDindicator should be ON to indicate a proper connection. Note:HSG260 has two virtual zones Private and Public which are mapped toLAN1/LAN2 (192.168.1.254) and LAN3/LAN4 (192.168.11.254)respectively.Now, the hardware installation is completed.To double verify the wired connection between HSG260 and yourswitch/router/hub, please check the LED status indication of thesenetwork devices.