89 North PhotoFluor II Operating Manual
Also see for PhotoFluor II: Replacement guide
                                 | |
Rev D 104 Initial SetupSystem ComponentsThe PhotoFluor II and PhotoFluor II NIR illumination systems arecomprised of: Light Source Liquid Light Guide (specific to both the PhotoFluor II and thePhotoFluor II NIR) Microscope Adapter (as required) Electrical Power Cord USB to Serial adapter BulbCarefully unpack all components, giving particular care to the liquidlight guide. The light guide should never be bent severely or it willsustain irreversible damage. Also take care not to touch orcontaminate the ends of light guide. If necessary the ends can becleaned with isopropyl alcohol and a soft cloth.Picking a LocationSet the light source on a flat surface in a place that allows foradequate air ventilation on all sides. Do not position the unit so thatany of the sides (including the back or the top) are up against a wallor other equipment.NOTE: Maintain at least 6” of clearance around all sidesof the light source for adequate ventilation.Light Guide ConnectionPush the wider end of the light guide into the acceptor at the back ofthe unit until it snaps in place. Do not force the light guide.Using an Allen wrench, attach the adapter (as required) to the epi-illumination port of the microscope. Insert the end of the light guideand secure in place by turning the red knob firmly to the right.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine