A-Collection aFlood LED Slim 800 Instruction Manual
        |
LED floodlightInstruction ManualPlease read the instruction sheet carefully before use:1. Main structures and application fieldsThe enclosure of the LED floodlight is made of glass and aluminum alloy with high purity. Intended for outdoor use.ENModel IP Classification InputPowerWeight MaximumProjected AreaSizeaFlood LED Slim 800 IP65* 10W 530G 0.013 m² 125*104*27 mmaFlood LED Slim 2400 IP65* 30W 830G 0.035 m² 209*168*27 mmaFlood LED Slim 4000 IP65* 50W 1210G 0.047 m² 237*200*36 mmaFlood LED Slim 1600 Sensor IP44 20W 670G 0.024 m² 189*125*55 mmaFlood LED Slim 4000 Sensor IP44 50W 1270G 0.057 m² 287*200*57 mmRequired Installation wire: 3G*1.0 mm H05RN-F 300/500VProtection Class level: Class IInput voltage: AC220-240V 50/60HzRange of mounting heights: 1-3 m3. Attention(1) In order to ensure the product works properly, please use the power supply within indicating voltage and current;(2) Cut off supply before installation or repair(3) If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufactureror his service agent or a similar qualified person in order to avoid a hazard.(4) Luminaire suitable for surface mounted direct on normally flammable surface.(5) If the protective glass is damaged or cracked, do not use the armature and discard it.(6) The luminaire should be at least 1m distance from projection object1m(7) The light source of this luminaire is not replaceable. When the light source reaches its end of life the whole luminaireshall be replaced.(8) In case of radiation interference, PIR sensor may be affected, lights will turn on even without induction.(9)The glass is tempered glass, will form small particles after impact and not cause harm to human body.4. Instruction for sensor ( Detective Angle 120°)When somebody pass by the detective range of sensor, the light will turn on automatically. And it will turn off whenthere is no continuous action in a setting time. The detective distance, working delay time and sensitive illumination canbe adjusted according to requirement.1) SENS: Adjust the detective distance of sensor ( 2-8M ).A. Set it to Max., the longest distance is 8 meters.B. Set it to Min., the longest detective distance is 2 meters.2) TIME: Adjust the working delay time (10 seconds - 10 minutes).A. Set it to MAX., the light will turn off automatically after 10 minutes approximately when there is no continuous action.B. Set it to Min., the light will turn off automatically after 10 seconds approximately when there is no continuous action.3) LUX: Sensitive illumination (5-2000LUX)A. Set it to MAX., the light can turn on automatically when somebody move into the detective range, both in daytimeand at night.B. Set it to Min., the light will turn on automatically only at night when somebody move into the detective range.5. Environmental protection2. Technical data*IP44 Plug To make it an IP65, a permanent connection is required. Depending on the socket’s IP Code, use a plug that achieves at least an IP 44. |
Related manuals for A-Collection aFlood LED Slim 1600 Sensor
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine