A4Tech G7-540 User Manual

Also see for G7-540: User manual

Contents

A4Tech G7-540 User Manual Manual pdf 2 page image

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWOCONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANYINTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.Federal Communications Commission RequirementsThe equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thisequipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:●Reorient of relocate the receiving antenna.●Increase the separation between the equipment and receiver.●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.●Consult the dealer or an experienced radio/TV technician for help.THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULDVOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.FCC Radiation Exposure StatementThe equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines inSupplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).Hardware Installation1. Pull out the nano-receiver from thebottom of mouse.2. Plug nano-receiver into USB port of your computer or notebook.3. Insert the supplied battery, make sure that the positive (+) and negative (-) ends of the battery match the polarity indicatorsinside the battery housing.Power Management of the Mouse1. To power on the mouse, switch the power button to “1” position.2. To turn off the mouse power, switch the power button to “0“ position.Note: The mouse can be activated from sleeping mode easily by moving it around.The wireless mouse is plug-and-play. No driver is required. If you would like to get more function, please install the software (enclosed on the CD)first.Mouse Button IdentificationThe “Gesture Button” can be set to various functions in using our 16 in 1 software.