IM 798 AE Self-Contained Unit Ventilator / Page 51 of 60165/8" (422mm) DeepEnd Panel217/8" (556mm) DeepEnd PanelTop ViewEnd ViewWith NoCut-outFigure 100 – 1" (25mm) and 6" (152mm) End Panel DimensionsTop ViewEnd ViewWith NoCut-out6" (152mm) End Panel1" (25mm)End Panel19 5/8" (498mm) DeepEnd Panel28" (711mm) DeepEnd PanelStep 7 – Installing Wall Filler, Spacer, End Panel27 7/ 8"(708mm)16 5/ 8 "(422mm) 1"(25mm)27 7/ 8"(708mm)28"(711mm) 1"(25mm)27 7/ 8"(708mm)27 7/ 8"(708mm)19 5 / 8"(498mm) 1"(25mm)21 7 / 8"(556mm) 1"(25mm)16 5 / 8 "(422mm)6"(152mm)28"(711mm)19 5 / 8"(498mm)21 7 / 8"(556mm)6"(152mm)6"(152mm)6"(152mm)27"(686mm)3" (76mm)27"(686mm)3" (76mm)27"(686mm)3" (76mm)27"(686mm)3" (76mm)Dashed lines indicate kickplateEnd Panel AssemblyThe final step of unit installation is attaching the end panels. Endpanels are required unless the unit has adjoining matching cabinets.1. Refer to Figure 101 for a 1" thick end panel. Attach two (2)Tinnerman nuts to the top edge of the end panel and two (2) to thebottom end of the unit. Align the end panel with the front and topedges of the unit. Insert through upper mounting holes inside unitend compartment and thread into tinnerman clips on the endpanel. Attach the end panel to the unit using four (4) 5/32" hexsocket head fasteners provided.Figure 101 – 1" End Panel Figure 102 – 6" End Panel with Provided HardwareBracketYC1934End of Unit2. Refer to Figure 102 for 6" thick end panel.a. Position bracket (YC1934) on wall so angle is 5" from end ofunit and near bottom.b. Mark and drill required hole for device to fasten bracketto wall (not included).c. Attach the bracket to wall.d. Attach two (2) Tinnerman nuts to the top edge of the endpanel and one (1) to the bottom front of the end frame.e. Align the end panel with the front and top edges of the unit.Attach end panel to the unit using three (3) 5/32 " hex sockethead fasteners provided. Bracket should prevent movementof panel toward the unit when pressure is applied to the endpanel.6" EndPanel1/4"-20 Tinnerman Nut,Clip on End Panel 1/4"-20 x 1/2" Screw &1/4" Flat Washer5"1/4"-20 Tinnerman Nut,Clip over Lower Hole inUnit Corner BracketTinnerman Nut,Clip on End Panel1" End Panel1/4"-20 x 1/2" Screw1/4"-20 Tinnerman Nut, Clip overLower Hole in Unit Base16 5 / 8 " UnitProjection 1/4"-20 x 1/2" ScrewCondensate Drain(By Others)