AAMP Global PAC RP4-FD11 Instructions Manual
RP4-FD11Radio Replacement & Steering Wheel Control Interfacefor Ford/Lincoln/Mercury Vehicles© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.PAC-audio.comPacific Accessory CorporationRev: 1.3Date: 072018Page 1RP4-FD11Introduction & FeaturesImportant NotesWiring Connection ChartThe RP4-FD11 interface allows the replacement of a factory radio in select Ford/Lincoln/Mercury vehicles with MSCANdatabus radios. Using this interface will retain factory features such as steering wheel controls (SWC), rear seatentertainment (RSE), rear seat controls (RSC) and the THX or Sony amplifier when the original radio is removed. Use ofthis interface also allows you to program two radio functions to each SWC button by using short press long press dualcommand functionality. The RP4-FD11 also provides data bus driven outputs such as retained accessory power (RAP),vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.1. These instructions only apply to modules equipped with the V2 harness.2. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging theinterface into the vehicle (see next page for setting chart).3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unlessyou wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can alwaysbe restored to default settings by pressing and releasing the program button on the side of the interface once and waiting 7seconds for the LED to flash 4 times.4. 2005-07 Ford Freestyle, Mercury Montego and Ford Five Hundred - In order for SWC to function in these vehicles you mustre-calibrate the SWC using the procedure outlined on page 4.5. RSC buttons that are identical to the SWC will mimic the SWC one for one. All other buttons cannot be programmed.6. The LED will flash whenever a SWC button is pressed.7. When used in a vehicle equipped with an LCD screen, the screen will display the SWC functions as they are pressed onthe steering wheel. It will also display “Programming Mode” whenever the programming button on the side of the interface ispressed.8. The RSC must be in AM mode for track +/- to function. RSC must be set to AUX mode to pass audio to aftermarket radio.9. Vehicles equipped with a factory amplified system must disconnect SYNC if they wish to use the voice button. Not disconnectingSYNC will result in the rear speakers muting every time the voice button is pressed.10. Feeding too strong of an audio signal into the headrest monitors will cause the audio output to shut down. If this happens youmust turn the tv off and on and lower the audio signal.Green Parking BrakeOutput (-)Pink Vehicle SpeedSignal OutputBlue / White Amp Turn On InputRed Accessory Output(1 amp)Orange / White Illumination Output(+)Purple / White Reverse Output (+)Interface ConnectorYellow Battery +12vBlack GroundBlue Antenna On InputWhite Front L + inputWhite / Black Front L - inputGray Front R + inputGray / Black Front R - inputGreen Rear L + inputGreen / Black Rear L - inputPurple Rear R + inputPurple / Black Rear R - inputVehicle Connector SWC ConnectorBlue / Yellow Kenwood, NewerJVC3.5mm Jack Alpine, JVC,Clarion, FusionPioneer, Sony,Boyo, Dual,Lightning Audio,Visteon or AdventPage 1 |
Related manuals for AAMP Global PAC RP4-FD11
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine