AAMP Global PAC RadioPRO RPK5-GM4101 Manual
         |
Page 1Pacific Accessory Corporation® | 866-931-8021 | support@pac-audio.com©2016 Pacific Accessory Corporationwww.pac-audio.com Rev. 061716Pacific Accessory CorporationPAC is an AAMP brandRPK5-GM4101Complete Radio Replacement Kit withIntegrated Climate Control Retention for2010-2015 Chevrolet CamaroRemoving the factory radio from the vehicle1.1 - Apply the parking brake. Move the transmission shiftassembly to the most rearward position possible. Use aflat bladed plastic trim tool and release the retainer tabssecuring the front floor console front cover to the consoleassembly. Lift the cover (1) up and rearward making sure thatthe accessory power receptacle and the electronic tractioncontrol switch clears the transmission shift assembly. It may benecessary to pop them loose from the underside to achieveclearance. Disconnect the electrical connections.1.2 - Remove the 2 x 7mm bolts (1) securing the radiocontrol assembly (2) into the dash. Then use a flat-bladed plastic trim tool in order to release the retainerclips securing the radio control assembly (2) to theinstrument panel. Disconnect the electrical connections.Parts ListThe RPK5-GM4101 includes everything you need for a professional installation of an aftermarket radio in your Camaro.This kit contains:1. Dash Kit• (x1) PAC HVAC Control Panel (Transfer of the factory HVAC knobs is required. See instructions below)• (x2) Radio Mounting Brackets (One left and one right)• (x1) Pocket (For single din applications)• (x8) Radio Mounting Screws2. RP5-GM4101 (Camaro specific radio replacement module)3. Camaro specific antenna adapter (BAA-DIN22).4. Rear camera retention cable for vehicles equipped with the MyLink system.5. USB retention cable. This cable is compatible with vehicles equipped with the MyLink radios and vehicles equipped with thestandard non-touchscreen radios. It will require that the cable be ran to the back of the center console.6. AUX retention cable for 2010-2012 vehicles equipped with the standard non-touchscreen radios also equipped with a USB port.OverviewThe RPK5-GM4101 is a complete radio replacement kit with integrated climate control retention for the 2010-2015 ChevroletCamaro. This kit utilizes the factory HVAC control knobs for a more factory look and experience. To add to the factory lookand experience the exterior temperature display is retained by a small OLED display at the top of the kit retaining this valuablevehicle feature. This kit also includes all of the modules and cables needed to retain all of the important features of the factorysystem such as OnStar, factory warning chimes, factory Bluetooth, steering wheel mounted radio controls, factory reversecamera, factory amplifier (if equipped), AM/FM reception, factory AUX jack (if equipped) and the factory USB port (if equipped).Table of Contents: Page:1. Factory Radio Removal ------------------------------------------------------ 1-22. Disassembly of the factory HVAC control module --------------------- 2-33. Assembly of the PAC HVAC control module ---------------------------- 3-44. RP5-GM4101 Instructions --------------------------------------------------- 4-65. AUX & USB Cable Installation ------------------------------------------------ 76. Temperature Display Settings ------------------------------------------------- 77. Sub-Dash Preparation ----------------------------------------------------------- 78. Kit Assembly Instructions ------------------------------------------------------- 89. Installation of the PAC HVAC control module --------------------------- 8-9 |
Related manuals for AAMP Global PAC RadioPRO RPK5-GM4101
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine