VCC-X Operator Interface SDMODULAR SERVICE TOOL SD11Modular Service Tool InitializationModular Service Tool Initialization Screen andSetup ScreensAfter connecting the Service Tool to the controller with the suppliedcable, press . The Initialization Screen will appear followedby the Setup Screens as shown below. If there is no SD card in-stalled, the second screen will display, “No SD Card Connected!Powering Down!”InitializingService Tool vX.XXWattMaster Controls1) Set Time & Date2) CommunicationsNEXT) More OptionsESC) Exit Menu3) Energy Saving4) Update SoftwareNEXT) More OptionsESC) Exit MenuNOTE: Once you press while at the Setup Screensshown above, you can access them again by pressing or cycling power.Initialization & Setting the Time & DateSetting The Time & DateThe Modular Service Tool is equipped with a real time clock chipallowing it to maintain the correct time. Once you have programmedthe correct time and date, the information is broadcast globally toall controllers on the entire system.NOTE: If you are in a time zone that has daylight savings,you will need to manually adjust the time twice a year.Programming the TimeFrom the Setup Screen shown below, press <1> on your keypad toaccess the Set Time & Date Screens. (You may have to press to access this screen).1) Set Time & Date2) CommunicationsNEXT) More OptionsESC) Exit MenuAlthough the times are displayed on the Main Screen in a standard12-hour format, you must program them using the 24-hour militaryformat. If you configured the VCC-X Controller to use its ownInternal Schedules, the Occupied/Unoccupied modes are calculatedon the basis of the current real time clock reading.The two screens that follow will appear. To scroll through the fields,press <> or . In order to save a new value, you mustpress .Program Time/DateDay (Sunday=0): XEnter Hr. (0-23): XXEnter Minutes : XXDay - Enter the Day of the Week (0 to 6)Sunday = 0Hours (Hr) - Enter Hours in 24-Hour Military Format(1700 = 5:00 PM)Minutes - Enter the Minutes(0 to 59)Programming the DateTo scroll through the fields, press <> or . I n order tosave a new value, you must press .Program Time/DateMonth (1-12): XXDay (1-31): XXYear (00-99): XXMonth - Enter the Month (1 to 12)Day - Enter the Day of the Month (1 to 31)Year - Enter the current Year with two digits(00 to 99)When you have finished programming the time and date, press to return to the Setup Screen shown below.1) Set Time & Date2) CommunicationsNEXT) More OptionsESC) Exit Menu