|
16PROGRAMMING YOUR ALARMGETTING INTO PROGRAM MODEThere are 2 levels of program mode, CLIENT mode and INSTALLERmode. Normally the installer will give you access to the CLIENT mode soyou can add, delete, or change the user codes.In CLIENT mode you can program up to 100 individual User Codes thatmay be 1-6 digits in length. Each of the 100 Users can be assigned NOaccess, LIMITED access or FULL access to CLIENT mode. A User withFULL access can change all access codes, change the panel time & date,change the telephone numbers, change the remote control codes (DTMF),add or remove radio devices, initiate Walk-test mode and access somediagnostic features. All of these things can be explained in detail by yourinstaller.To get into CLIENT mode provided the system is NOT armed press; The Program LED with turn ON (LED keypad) orThe LCD Keypad will display “CLIENT : USERS”If you get a single long beep at this point and the above indications do nothappen it means your code cannot access Program mode.EXITING PROGRAM MODETo exit out of program mode press; (LED Keypad)Program LED will turn Off or;Press and hold for 2 seconds (LCD Keypad)ADDING OR DELETING A USER CODEOnce in CLIENT mode, to program a User code you enter the User codeaddress (Program location 1) then the code address 1-100. For exampleto program User # 3 with a code “2580”, key in the following sequence: <1> <3> <2580> (eg P1E3E2580E)If there is an existing code already at that address it will be displayed on
PreviousNext |