NVIP-2VE-6601 - User’s manual (short form) ver 1.0All rights reserved © AAT Holding S.A.9START-UP AND INITIAL IP CAMERA CONFIGURATION2.2. Ethernet cable connectingTo maintain tightness of ethernet cable connection, please follow instruction below:1. Unscrew the nut (1) from the connector cover (2).2. Route the network cable (without the RJ-45 plug) through the components (1) and (2), than crimp theRJ-45 connector.3. Plug the RJ-45 connector into the hermetic socket (3), screw the connector cover (2), and than thenut (1).CAUTION!The declared degree of protection of the camera relates to its housing and does not take intoaccount the possibility of moisture infiltration into the camera by connection cables. Connectioncables protection through i.e. sealing up is the camera installer duty. The manufacturer is notliable for any camera damages caused as a result of failing in performing that activity byinstaller, which also means that camera damaged in that way is not subject to warranty repairs.CAUTION!Camera power supply connector is not hermetic. Installer should seal this connector by himself.Camera can be supplied using external power supply unit corresponding with the camera parameters orby using RJ45 network socket and PoE (802.3at/af) power supply unit. If you’re using external powersupply please connect wires according to polarisation shown on picture:CAUTION!In order to provide protection against voltage surges/lightning strikes, usage of appropriate surgeprotectors is advised. Any damages resulting from surges are not eligible for service repairs.12 VDC +GNDSchema of 12VDC power supply connector1 2312