115.1. Programming the remote control for your TV set.This Universal type remote control works for both TV and PVR.There are two ways to program the remote control; Automatic Code Search and Direct Entry.5.1.1 Using automatic code search1. Turn on the component (TV) you want to control.2. Press and hold the TV button until the LED (TV button) turns on red, then release thekey.3. Point the remote at the component (TV), press and release the UP (▲ ) button, and thenwait three seconds or until the LED stops flashing.At this point the remote control is searching for the correct code to program. If, after threeseconds, the component (TV) you want to control does not turn off, press and release UP(▲ ) button again to make the remote to search the next set of codes.4. If the component you want to control does turn off; Press and release OK button, thenthe LED blinks three times.5.1.2. Using direct entry method1. Turn on the component (TV) you want to control.2. Locate the Code List (refer to code list on the page 59). Find your TV brand that you wantto control.3. Press and hold the TV button until the LED on the remote control turns on red, then releasethe key.4. Enter 3-digit code from the code list, then the LED blinks three times.5. If you get no response, repeat these steps using the next code listed for your TV branduntil the component responds to the remote control command.5.1.3. Locking the volume control.Locking the volume controls to a single device makes it easier to control volume, withouthaving an unexpected volume change. If you lock the remote's volume controls to the TVset, you will be always able to change the volume to the level you want, without havingadjusting it twice on multiple devices.If you want to lock the volume for the TV system;