ABB A175-M66 Operation Manual

Also see for A175-M66: Operation manual Operation manual Operation manual Operation manual Operation manual

ABB A175-M66 Operation Manual Manual pdf 19 page image

Operation Manual / 2 Safety / A100-M axial1 Safety Page 9 / 171.10 Lifting of loadsWARNINGSuspended loadsLoads that are not attached according to regulations can cause injury to per-sonnel or fatal accidents. Loads must always be fastened to properly functional lifting gear with asufficient load limit. Pay attention to the correct attachment of loads on the crane hook. People must not stand beneath suspended loads.Wear safety gloves to protect against mechanical hazards.Wear safety helmet.Figure 3: Attachment of loads on the crane hookFigure 4: Attachment angleIf there are two or more suspension points, the attachment angle of 45° must not be exceed-ed. This prevents excessive loading due to diagonal pull. Before looping around the components of the turbocharger, let them cool down (maximum80 °C). Attach components of the turbocharger as described in the respective action steps. Use a suitable edge guard if there are sharp edges. The assembly devices must be completely screwed in and must not unscrew during use. Use assembly devices only for the described applications. Put down dismantled components of the turbocharger in such a way that they cannot tipover.© Copyright 2016 ABB. All rights reserved. HZTL4023_EN Revision B May 2016