Table 18. Electronic Key ParametersParameter DefaultValueDataType DescriptionElectronic KeyVendorIDDisableKeyingEnum When enabled, there will be a check to see if theVendor ID of the configured slave in Control Buildermatches with that of the device in the network, beforeconnection establishment.Values are: Enable Keying, Disable KeyingElectronic KeyProduct TypeDisableKeyingEnum When enabled, there will be a check to see if theProduct Type of the configured slave in Control Buildermatches with that of the device in the network, beforeconnection establishment.Values are: Enable Keying, Disable KeyingElectronic KeyProduct CodeDisableKeyingEnum When enabled, there will be a check to see if theProduct Code of the configured slave in Control Buildermatches with that of the device in the network, beforeconnection establishment.Values are: Enable Keying, Disable KeyingElectronic KeyMajorRevisionDisableKeyingEnum When enabled, there will be a check to see if MajorRevision of the configured slave in Control Buildermatches or is higher than that of the device in thenetwork before connection establishment.Values are: Disable Keying, Exact Match,Current and HigherSection 4 Configuration Communication Related Parameters9ARD000014-600 A 125Communication Related ParametersCommunication related parameters have a bearing on the communication betweenthe DeviceNet device and the linking device LD 800DN. The communicationrelated parameters depend on the type of connection trigger types supported by theslave device. The four possible connection types that can be supported by a deviceare:• Poll Connection (see Poll Connection on page 126)