ABB ACS 502 Series Installation & Start-up Manual

Contents

ABB ACS 502 Series Installation & Start-up Manual Manual pdf 69 page image

Chapter 5 – Start-up ProcedureACS 502 Installation & Start-up Manual5-3Start-up DataParametersPower up the ACS 502. The display shows Operating Data Parameter 1(Output Frequency). Before proceeding with the start-up, check and completethe Start-up Data Parameter values. Do not change parameters at this timeexcept as described in the following steps.While viewing Parameter 1 (Output Frequency) press and hold [ * ], thenpress [Right Arrow]. The display shows Parameter A (Language) in Settingmode.A LANGUAGE Press [Up Arrow] or [Down Arrow] to select your preferred language. TheACS 502 displays all information in the language you select. Press [ * ] toconfirm the selection and move to the next parameter. The available languagesare: English, German, Italian, Spanish, Dutch, French, Danish, Finnish, andSwedish.B APPLICATIONS Leave this in the FACTORY setting to perform the start-up procedure. Ifanything other than FACTORY displays, press [Up Arrow] or [Down Arrow]to change the parameter to FACTORY. Press [ * ] to confirm the selection andmove to the next parameter.C APPLIC. RESTORE This parameter restores all parameters of the current application to factory-setparameter values. Set this to YES by pressing [Up Arrow]. Press [ * ] toconfirm the selection and move to the next parameter.D SUPPLY VOLTAGE This parameter offers choices of 440, 460, 480, and 500 VAC for 480-voltunits or 380, 400, and 415 VAC for 380-volt units.Press [Up Arrow] or [Down Arrow] to select the voltage value matching linevoltage providing power to your ACS 502. Press [ * ] to confirm the selectionand move to the next parameter.E USER DISPLAYSCALEThis parameter is used to set the scaling factor for Operating Data Parameter 2(Speed). When set to 0, the speed display will show RPM. When set to 100,the speed display will show %. When set to any other value from 0 – 10000,the display will show this value (minus slip unless slip compensation is ON)when the output frequency is at the frequency set by Start-up Data Parameter I(Motor Base Frequency).Press [Up Arrow] or [Down Arrow] to set the desired value of the speeddisplay. Press [ * ] to confirm the selection and move to the next parameter.F MOTOR CURRENT-FLAThis parameter matches the ACS 502 to the rated motor current, adjustablebetween 0 and 1000 amps. The drive uses this parameter for motor overloadprotection and current (amperage) information displays.Press [Up Arrow] or [Down Arrow] to select the current (amperage) value foryour motor. Press [ * ] to confirm the selection and move to the nextparameter.