ABB ACS 600 Installation Manuals

Also see for ACS 600: Hardware manual Startup guide Installation and startup guide Supplement to Firmware Manual Hardware manual

ABB ACS 600 Installation Manuals Manual pdf 1 page image

6Lead the motor and mains cables through thebottom plate.ENSURE MAINS SUPPLY TO INSTALLATION IS OFF.LOCK THE DISCONNECTOR TO OPEN POSITION.ACx 600 MUST BE INSTALLED BY A COMPETENT PERSON.IF IN DOUBT DO NOT INSTALL.11. Measure the places for four screw holes.Mark the hole positions. 2. Drill the holes.3. Screw in the screws.2Position ACx 600 onto screws and securelytighten in all four corners.Note: Lift ACx 600by its chassis, not by its cover.1. Undo the two screws. 2. Lift the lower edgeof the cover. 3. Disconnect the cable fromconnector X2. Remove the cover.STOPFORINSTALLATIONOF OPTIONALEQUIPMENT, SEESEPARATEINSTRUCTIONSINCLUDED INTHE DELIVERY.4 51. Strip off the insulation from the motor cableand mains cable. Twist the screen wires intobundles. 2. Make suitable holes to motor andmains cable grommets.Before Starting InstallationCHECK BOX CONTENTS: ACx 601, Manual(s), Testing report, Ordered options, Quick Guide(s)CHECK INSTALLATION SITE AMBIENT CONDITIONS: See Manual.CHECK INSTALLATION SPACE: ACx 600 free space requirements are 300 mm above and below, 50 mm on the left and on the right.CHECK INSTALLATION SURFACE: Vertical, smooth and solid, free from heat, damp and condensation.CHECK ACCESSORIES NEEDED: See Manual for fuse, supply disconnecting device and cable specifications.3Mains cableOUTPUTSTOPCHECK THEINSULATIONSOF MOTOR,AND MAINSAND MOTORCABLE.See Manual.72.1.3.2.1.3.1.2.INPUTMotorcable300 mmfree spaceACS 600 Installation GuideACS/ACC/ACP 601-0005-3 ... -0016-3,-0006-5 ... -0020-5 and -0009-6 ... -0020-6106-76-715X2

/ 2

Related manuals for ABB ACS 600