—ABB industrial drivesACS580MV Synchronized Bypass UnitHardware manual

ABB ACS580MV Hardware Manual

ACS580MV

EFFECTIVE:2018

Contents of this chapter

Identifying a drive from package

Safety

Installation of EC fan units

Bolting together the units

Location of tool kit and accessaries

Drawing of system cabling

Cables requirements

Installing power and ground cables

Installing auxiliary, control and serial communication cables

Sealing holes in entry plates

Status indications

Energizing and starting the drive

Stopping the drive

Replacing the memory unit

Product and service inquiries

Terms

Trademarks

User's responsibilities

Possible residual risks

Safety labels

Electrical safety in installation, start-up and maintenance

Additional instructions and notes

Target groups and required qualifications

Maintenance

Intended equipment use

Rating plate

System overview

Auxiliary power supply

Terminal unit

Transformer unit

Power module

Charging circuit

Control unit

Cabinet design

Cooling system

Temperature monitoring

Control block diagram

Control unit (BCU)

Control tasks

Control locations and operating modes

Supply OFF/ON pushbuttons

Alarm and fault indications

I/O signal requirements

References

Unpacking and inspection

Using a crane

Using a forklift

Storage

Reforming capacitors of the power modules

Necessary tools

Cabinet roof

Location of tool kit and accessories

Cable requirements

Ground cable and cable shield connections

Cables and PE busbar between integrated transformer and drive

Cable entries for external connections

Connecting the cables

Connections

Preparing the cable entry and the cables

Preparing the cables

Control and power supply cables for fan units

Final checks

Checklist

Overview on drive status and sequences

Start sequence of the drive

Stop sequence of the drive

Emergency stop sequence

Starting the drive from remote

Warning and fault messages

Preparation for maintenance work

De-energizing the drive

Unlocking and locking the doors

Grounding power module with grounding hook

Procedure

Safety-switch settings

Unlocking

Cleaning the interior of the cabinet

Cleaning heat sinks of power modules

Replacing roof AC fans

Required tools and equipment

Replacing roof EC fans

Replacing the power modules

Dismounting

Mounting

Replacement of a power module frame size R4 - R6

Replacement of a power module frame size R7 - R9

Replacing the power module fuse R7 - R9

Replacing the SD memory card

High voltage divider board

Control hub daughter board

Maintenance schedule